Welcome to the CAN-bus Wiki project

This is an old revision of the document!

CAN with flexible Data Rate -- improved CAN

More than 20 years after introducing CAN, communication requirements have increased and CAN has reached it's bandwidth limits in some application fields. To improve CAN regarding bandwith Bosch has specified the improved CAN data link layer protocol, called CAN FD. The idea behind CAN FD is that after the arbitration phase of classic CAN the data rate can be increased. The data bits are transferred with a higher bit rate than in the arbitration phase when a transmitter has won the bus arbitration. The speed is limited only by the CAN transceiver signal delay and the signal delay on the cable.
Besides the increased bit speed the new CAN FD allows date frames up to 64 bytes compared with the maximum of 8 bytes with classic CAN.

For more information see the Bosch CAN FD Specification Version 1.0 or the older CAN-FD Whitepaper (V1.1) . Official introduced by BOSCH at the 13th international CAN Conference in March 2012.
Since May 2012 the new M_CAN manual contains specific information on CAN FD used in this FPGA IP.

CiA provides information on CAN FD and organizes world wide events to promote it.

The Linux CAN device driver can4linux supports this frame format already in it's 'virtual' mode. The same is true for the SocketCAN approach.

Kvaser demonstrates CAN FD capability

QR Code
QR Code can_fd (generated for current page)